Home > Products > Helicopters > Electric FBL Helicopter NEX E6 series > [Characteristic 2] STF Linkage provides Direct control.

Electric FBL Helicopter NEX E6 series

NEX E6-550

STF Linkage provides Direct control.

NEX E6 series are employed with STF (i.e. Sub Trim Free) full metal servo train.

STF system offers without sub trim adjustment on transmitter and ease setting onto the helicopter. By using metal structure, it provide direct control to the each control so that it gives higher response to your control.

 

NEX E6-550 RTFフルセット NEX E6-550 RTFフルセット NEX E6-550 RTFフルセット

 

Setting procedure for STF linkage

NEX E6-550 RTFフルセット

Installation of the swash servo

NEX E6-550 RTFフルセット

Fixing the inner spline post to the servo. The aluminum made post has spline on one side. It provides rigid fixture to the JR servos.

NEX E6-550 RTFフルセット Showing the servos with Spline post attached.
NEX E6-550 RTFフルセット

For the convenience, there is a pin going through the frame to acknolwedge the neutral position. Set the neutral position on the transmitter, Metal servo horn should be free at this stage.

NEX E6-550 RTFフルセット Clamp the Spline post by using hex screw on metal servo horn.
NEX E6-550 RTFフルセット Figure of the Servo showing at the outside of frame for better comprehension.
NEX E6-550 RTFフルセット

Elevator linkage should be used with long Spline post fixed on the servo.

NEX E6-550 RTFフルセット

After installation of the each Swash servos, set the neutral position on transmitter for all the swash control, thence fix the hex screw at the metal servo horn on each.

NEX E6-550 RTFフルセット Figure of the Servo showing at the outside of frame for better comprehension.

Completion of the servo installation

NEX E6-550 RTFフルセット

NEX E6-550 RTFフルセット For the tail rudder servo, Spline post should be used with shortest one.
NEX E6-550 RTFフルセット
NEX E6-550 RTFフルセット
As same as the Swash control Spline post, Fixing the spline post to the tail rudder servo. The post has spline on one side.
NEX E6-550 RTFフルセット

Attach the metal servo horn onto the Spline post installed tail rudder servo. Set the neutral on transmitter for rudder stick control.

NEX E6-550 RTFフルセット Clamp the Spline post by using hex screw on metal servo horn.
NEX E6-550 RTFフルセット It is more convenient to proceed this installation upon fixing the tail rudder servo onto the helicopter but, showing it individually for better comprehension.

 

* Kindly note in advance that some of the assembly procedure has been deleted on this quick review and provided the clear plastic for better understanding however, be certain to follow the instruction manual upon assembly.




Optional parts